Multifunctional Dust Removal Floor Sweeper Vacuum Driving Road Sweeper Street Sweeper Clean Machine

The BC175 is designed for large industrial, logistics and outdoor cleaning areas. Its 1,750mm sweeping width and rated efficiency of up to 16,600m²/h make it suitable for factories, logistics centers, large warehouses, parking facilities, industrial roads and commercial campuses.

The theoretical coverage is approximately 49,800–83,000m² per charge. This estimate is calculated from the rated efficiency of 16,600m²/h and the specified working time of 3–5 hours. Actual coverage will be lower because of turning, overlapping, hopper unloading, obstacles, gradients and operating speed.

The BC175 requires wide access routes because the machine body is 1,750mm wide and 2,050mm high. Its complete dimensions are 2,300 × 1,750 × 2,050mm. Buyers should measure gates, warehouse doors, aisles, overhead restrictions, turning areas, charging locations and storage entrances before purchase.

The supplied data confirms a 600W main-brush motor and four 140W side-brush motors, but it does not provide a complete 3,000W power breakdown. These listed brush motors total 1,160W. The remaining 1,840W may include the drive motor, suction fan or other systems, so buyers should request a complete motor list and electrical schematic.

The 80L hopper is suitable for routine sweeping, but it may require more frequent unloading when the machine operates at high output. Fine dust and sand may allow longer routes, while bulky leaves, packaging waste and larger debris can fill the hopper more quickly. Hopper capacity should be compared with the actual site waste stream.

The listed climbing capability is below 25%, but the safe operating gradient must be confirmed for the actual site. Performance varies with battery charge, surface traction, hopper load and driving direction. Buyers should request the rated working gradient, braking specification and slope-safety instructions before ramp use.

The BC175 has a listed maximum working speed of 11km/h and is configured as a powered ride-on sweeper. Actual sweeping speed should be reduced for dusty, congested or heavily contaminated areas. Buyers should confirm drive-motor power, reverse speed, braking system and traction performance on wet or sloped surfaces.

The confirmed specification is a 48V battery system with a stated working time of 3–5 hours. Battery capacity, chemistry and charging time are not included in the supplied parameter sheet. Confirm the amp-hour rating, lead-acid or lithium configuration, charger voltage, plug type and replacement-battery availability before ordering.

The supplied parameters do not state the filter area, filter-cleaning method or water-spray configuration. For dusty factories and outdoor roads, buyers should confirm the filter area, filter material, electric filter shaker, suction fan, spray system, water-tank capacity and replacement-filter availability.

Confirm the complete motor, battery, dust-control, safety and shipping configuration in writing. The purchase specification should include the full 3,000W power breakdown, battery capacity and chemistry, charger voltage and plug, filtration system, working gradient, braking system, supplied brushes, spare filters, warranty terms, packed dimensions, gross weight and unloading requirements.